Re: Compass Software

[mleuck <m.leuck@xxxxxxxxx>]

On Feb 2, 8:13=A0pm, Jim Rojas <jro...@xxxxxxxxxxxx> wrote:
> mleuck wrote:
> > On Feb 2, 9:18 am, "Crash Gordon"<webmas...@xxxxxxxxxxxxxxxxxxxxx>
> > wrote:
> >> One old CIA, then a brand new one. Two different sets of cables.
> >> Ademco says my com port is bad, but if I plug an entirely different mo=
dem in
> >> with same cables that works fine.
>
> >> --
> >> **Crash Gordon**
>
> >> "mleuck"<m.le...@xxxxxxxxx> =A0wrote in message
>
> >>news:0b9d4284-d84a-42bb-81b1-8d6c3ca71061@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx=
..
>
> >>> On Feb 1, 10:08 pm, "Crash Gordon"<webmas...@xxxxxxxxxxxxxxxxxxxxx>
> >>> wrote:
> >>>> my stupid Compass decide not to initiated the modem any more...pssin=
g me
> >>>> off
> >>>> big time. My other modem works on the same comport...Ademco, no help=
.
>
> >>>> --
> >>>> **Crash Gordon**
>
> >>> I've seen that happen before, it could be the modem, what are you
> >>> using?
>
> > It's the modem, unfortunately there usually isn't a fix, I've seen
> > that happen with older Hayes when they go out. They still work on DSC
> > and GE but won't on Ademco
>
> I downloaded a PC5020 v3.2 today. It was connected to a VoIP line. I
> tried the Ademco CIA, and PM1200SA Mini...no go. I finally broke out the
> MD12, and sure enough, that did the trick.
>
> Jim Rojas

My bet the reason you were able to do that is because the MD12
connects at a higher 625 baud on DSC panels whereas the other two
modems will only connect at around 110. All Power-series panels after
the PC5010 v1 will transfer at that higher rate