Re: Napco Gem-Trans2 Bug

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

Are they supervised..probably right...do they keep trying to send a
supervisory signal if it doesn't get through on 1st try or does it wait till
the next supervisory check in time?



--
**Crash Gordon**







"Bob La Londe" <nospam@xxxxxxxxx> wrote in message
news:h37u9o$66n$1@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> The first time this occurred I figured it was a one off circumstance, but
> I have had it happen a three times now.
>
> Gem-Trans2 keeps sending low battery signals.  Replace battery.  Restart
> receiver.  Restart panel.  Replace battery again, etc etc etc...
>
> Throw transmitter away and replace.  Problem solved.  These are with brand
> new installed transmitters with a fresh batteries reading over 3 volts
> under load.
>
> Just something I thought might benefit another installer.  The time spent
> is worth more than the transmitter.  If you get a low bat with a good
> battery or a fresh replace within a couple weeks just replace the
> transmitter and save the headaches.
>
>
>