Re: HELP! Ademco VISTA 20 P Zone Type 1 Won't Fault When Armed

[Jim Rojas <jrojas@xxxxxxxxxxxx>]

Wait until your exit delay expires. Then wait another 10 seconds longer
to keep the panel from going into Exit Error. It should work fine then.

Jim Rojas




villain383 wrote:
> villain383 had written this in response to
> http://www.secure-gear.com/alt.security.alarms/5/-article-.htm  :
>
> I have a Vista 20 P and I have three zones programmed with TYPE 1 that
> will not fault when the system is armed in either mode. When the system is
> unarmed the zones will fault with the chime and show faulted in the
> dispaly. The zones will also fault in the TEST mode and show on the
> display. They will not fault when the system is armed. Any ideas?
>
>
>
>
> ##-----------------------------------------------##
> Delivered via http://www.secure-gear.com
> The Internet Knowledge Base for the security industry
> no-spam access to your favorite newsgroup -
> alt.security.alarms - 44957 messages and counting!
> ##-----------------------------------------------##