Re: Networx NX-590-E

[santiagodeano@xxxxxxxxx]

On Apr 6, 4:45=A0pm, "ABLE1" <royboynos...@xxxxxxxxxxxxx> wrote:
> First of all thanks guys for your support on this, so here we go
>
> my network is very simple I have DSL with ATT, =A0and a linksys router
> setup with dhcp so the module will =A0take the =A0TCP configuration from
> it like =A0IP, mask, gateway as well as DNS etc , also the port is setup
> 10 Full is does not work 100 Full.
>
> That part is working because I can connect to the module using DL900
> using an IP and also the module is already enrolled so =A0at this point
> I believe everything is fine.
>
> The problems I have are :
> 1.- I have =A0Aux comm Fail on the Keypad
> 2.- The module never send emails ,the SMTP servers I am using is
> ATT.NET but I also test GMAIL and AOL , none of them works with the
> Module at least for me, =A0for each case I setup the correct smtp
> server, I=B4m using the hostname =A0for example for @att.netthe server
> name is smtp.att.yahoo.com and the SMTP port =A0is 465 with
> ( authentication), Also =A0I tested =A0the configuration using Static IP,
> and setup the smtp =A0server IP and I got the same results =A0, I am usin=
g
> a mail account =A0 that are already in use and fully working like
> aaaa.b...@xxxxxxx
>
> Hardware
> 1.- NX-8E
> 2.- NX-590e version 2.11
>
> Internet access details
> 1.- ATT DSL Moden speed stream 4100 soft ver 1.0.0.53
> 2.- Linksys router RV082 latest version
>
> =A0Any advice you can give me =A0will be greatly appreciated, at this
> point I am running out of ideas. also I=B4am not =A0a network expert.
>
> Ok, it seems that you have the right stuff and the right info.
>
> I can't answer the issues of the emails not getting thru since I have not
> tried nor do I care to try to make that work.
>
> Procedurally I would do the following and if it did not communicate I wou=
ld
> return it to GE and get another or find a different way to communicate.
>
> * 8 <CODE> 7 9 # =A0 9 1 0 # EXIT EXIT
> That will default the board and get a fresh start. =A0Would not hurt to d=
o
> power cycle at this point.
>
> Default the Router back to Factory if you can.
> Explorer................ 192.168.1.1 =A0User Name empty and password: =A0=
"admin"
> If you can't call Lynksys.
>
> Connect CAT5 Cable and make sure it is connected to network.
> Enter Programming and:
>
> Then turn on DHCP and Polling.
> Then enter the IP address into the "Primary Receiver" location.
> Then enter the Account Number with preceding zeros as in =A000001234
> Exit Exit Programming wait 30 seconds and power cycle system down for 30
> seconds. =A0>>> VERY IMPORTANT!!!!!!
>
> Send a signal and see if it arrives. =A0If it does Whoopie!!!! =A0If it d=
oes not
> BUMMER and trash the sucker..........
>
> And if it really does communicate you can then and only then try your ema=
il
> stuff.
>
> Let me know how it goes.
>
> Good luck.
>
> Les

Hi Les

when you say "Send a signal and see if it arrives. "  what you really
means by that,