Re: Networx NX-590-E

["KingFish" <al@xxxxxx>]

<santiagodeano@xxxxxxxxx> wrote in message
news:396aef5e-9776-4505-b005-d7cc5f442410@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Apr 6, 4:45 pm, "ABLE1" <royboynos...@xxxxxxxxxxxxx> wrote:
> First of all thanks guys for your support on this, so here we go
>
> my network is very simple I have DSL with ATT, and a linksys router
> setup with dhcp so the module will take the TCP configuration from
> it like IP, mask, gateway as well as DNS etc , also the port is setup
> 10 Full is does not work 100 Full.
>
> That part is working because I can connect to the module using DL900
> using an IP and also the module is already enrolled so at this point
> I believe everything is fine.
>
> The problems I have are :
> 1.- I have Aux comm Fail on the Keypad
> 2.- The module never send emails ,the SMTP servers I am using is
> ATT.NET but I also test GMAIL and AOL , none of them works with the
> Module at least for me, for each case I setup the correct smtp
> server, I´m using the hostname for example for @att.netthe server
> name is smtp.att.yahoo.com and the SMTP port is 465 with
> ( authentication), Also I tested the configuration using Static IP,
> and setup the smtp server IP and I got the same results , I am using
> a mail account that are already in use and fully working like
> aaaa.b...@xxxxxxx
>
> Hardware
> 1.- NX-8E
> 2.- NX-590e version 2.11
>
> Internet access details
> 1.- ATT DSL Moden speed stream 4100 soft ver 1.0.0.53
> 2.- Linksys router RV082 latest version
>
> Any advice you can give me will be greatly appreciated, at this
> point I am running out of ideas. also I´am not a network expert.
>
> Ok, it seems that you have the right stuff and the right info.
>
> I can't answer the issues of the emails not getting thru since I have not
> tried nor do I care to try to make that work.
>
> Procedurally I would do the following and if it did not communicate I
> would
> return it to GE and get another or find a different way to communicate.
>
> * 8 <CODE> 7 9 # 9 1 0 # EXIT EXIT
> That will default the board and get a fresh start. Would not hurt to do
> power cycle at this point.
>
> Default the Router back to Factory if you can.
> Explorer................ 192.168.1.1 User Name empty and password: "admin"
> If you can't call Lynksys.
>
> Connect CAT5 Cable and make sure it is connected to network.
> Enter Programming and:
>
> Then turn on DHCP and Polling.
> Then enter the IP address into the "Primary Receiver" location.
> Then enter the Account Number with preceding zeros as in 00001234
> Exit Exit Programming wait 30 seconds and power cycle system down for 30
> seconds. >>> VERY IMPORTANT!!!!!!
>
> Send a signal and see if it arrives. If it does Whoopie!!!! If it does not
> BUMMER and trash the sucker..........
>
> And if it really does communicate you can then and only then try your
> email
> stuff.
>
> Let me know how it goes.
>
> Good luck.
>
> Les

Hi Les

when you say "Send a signal and see if it arrives. "  what you really
means by that,

I think we found out where the FTC trouble is from.