Re: NX8 v2 problem...

["ABLE_1" <royboynospam@xxxxxxxxxxxxx>]

Start for scratch.

*8 CODE 0* 910* to default the panel.

Then before you start to re-program and you have a "READY TO ARM" use 1234
to arm.

If it does arm then you have(had) a programming problem.

If it does not then you have a board problem.

Simple.......................................

Good luck.


"Proguard Security" <proguard@xxxxxxxxxxxxxxx> wrote in message
news:1207714064.594829@xxxxxxxxxxx
> At the second code i get the same 3 beeps....  :-(
>
>
> Ï "ABLE_1" <royboynospam@xxxxxxxxxxxxx> Ýãñáøå óôï ìÞíõìá
> news:TJKdnZ3v1aes0mfanZ2dnUVZ_oCvnZ2d@xxxxxxxxxxxxxx
>>
>> Spyros,
>>
>> Under the description you have written I would say that the system is NOT
>> READY to arm at the moment you entered the code.  The code is good
>> otherwise you would not get the beeps.
>>
>> On a different thought check the history.  If the system still has a
>> previous trouble you will get the same beeps but then can arm the system
>> with a second code entry.
>>
>> Hope this helps and good luck.
>>
>> Les
>>
>>
>>
>> "Proguard Security" <proguard@xxxxxxxxxxxxxxx> wrote in message
>> news:1207583119.239484@xxxxxxxxxxx
>>> At one of my Caddx installations i've got a problem but i do not know
>>> the reason.
>>> Randomly, without any obvious reason, the system cannot arm even if all
>>> the zones are secure and the ready light is on.
>>> When we put the code the system sends us 3 beeps and the system cannot
>>> arm.
>>> System: Caddx NX8 v2 european version with 16 zones (zone doubled)
>>> Any idea??
>>>
>>> Thanks in advance
>>>
>>> Spyros Kintzonides
>>>
>>
>>
>
>