Re: Scantronic 500r+ reset tamper

["Paul Ekins" <pmekins@xxxxxxxxxxxxxxxxxxxx>]

purely from memory, I don't think the 500r needs eng code to reset a tamper.
You should be able to reset with the user code. Make sure the detector cover
is secured properly and it should transmit back to the panel. If after a few
attempts this doesn't work I would advise you replace the battery in the
detector. (yes the 500r is a radio panel)

good luck


A fine is a tax for doing wrong. A tax is a fine for doing well.

--
Paul Ekins

Linc Secure
Ph: 0845 123 2599
paul@xxxxxxxxxxxxxxxx
www.lincsecure.co.uk


"MyKey" <michaelwatt@xxxxxxxxxx> wrote in message
news:1176296356.890550.260530@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Can any alarm gurus out there help a noob out. I've accidently
> (stupidly) set off a tamper alarm by removing a detector from the
> wall. How can I reset the detector etc? The user manual says contact
> engineer for service, but I've no idea who installed the alarm. I have
> a copy of the installation and user guide but need some help to find
> the correct command. Do I need a special engineer code?
>
> Thanks in advance
> Mike
>