Re: Concord 4 programming

[ssokoly <alarmdude01@xxxxxxxxx>]

ssokoly wrote:
> Leon wrote:
>> Hi,
>>
>> I have 3 level split house with the daylight basement most vulnerable
>> to the intrusion. While I am going to have window/door sensors which
>> will be ENABLED in the STAY mode, I also want to have motion detector
>> enabled in the stay mode (basically when house is armed and we are
>> asleep upstairs) for this room only.
>>
>> If I put this motion detector to external perimeter group, then arming
>> perimeter in STAY mode will enable it.
>>
>> Problem:
>> 1. Once a while I have guest staying in this basement. When this
>> happens I don't want STAY command enable this motion detector.
>>
>>
>> Question:
>> 1. Can this be easily accomplished (with macro, etc) by some easy key
>> combination so my wife can do it, w/out me going into complex
>> programming options to configure it while guests are in?
>>
>>
>> I know that I can easily by-pass open window/door sensor and force ARM
>> operation, but I don't think I can by-pass motion sensor (since unlike
>> door, I can't just have it "opened" in the arming operation).
>>
>>
>> Thank you.
>> Leon
>>
>>
> Program your motion to sensor group 15 this will enable it to be active
> in Level 2(Stay) and Level 3 (Away). There is no way to make it either
> Stay or Away when you feel like it. Its either use Group 14 where the
> Motion will be active in Level 3(Away) or use Group 15 where it will be
> active in both arming levels. You can bypass a sensor directly, the way
> that you mention is by indirectly bypassing a sensor.
>
>
I should mention that if you program it to Group 14, and have auto stay
enabled the system will not arm to Away if you do not exit the premises.