Re: omnicron 9000s

["mojo7676" <mojo7676@xxxxxxxxxxx>]

Hi

turns out it was a blown fuse which has now been replaced.

thanks, once again, for the info - mojo





On 10 Feb, 15:36, "Crash Gordon" <webmas...@xxxxxxxxxxxxxxxxxxxxx>
wrote:
> And it he cut something in one place its very likely he cut something
> elsewhere and didn't say nuttin' about it.
>
> I had a client that had his carpet replaced almost everywhere in his house
> with TILE...yep they wacked a  bunch of wires and layed the tile right over
> it...then called us after the tile was set and grouted. DUH.
>
> "Paul Ekins" <pmek...@xxxxxxxxxxxxxxxxxxxx> wrote in message
>
> news:5_gzh.11889$wP3.4582@xxxxxxxxxxxxxxxxxxxxxxx
> | Hi Mojo
> |
> | Chances are pretty high that when carpet fitter cut cable it shorted the
> | power pair which has blown the "Aux fuse" in the main panel.
> | If you replace this and test again you should be OK. If system hasn't been
> | serviced for a while you may like to replace battery while the panel is
> | open.
> |
> | Regards
> |
> |
> | Paul Ekins
> | Linc Secure
> |
> |
> | A fine is a tax for doing wrong. A tax is a fine for doing well.
> |
> |
> |
> |
> || "mojo7676" <mojo7...@xxxxxxxxxxx> wrote in message
>
> |news:1171058934.183812.154600@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> | >I know this is an old system but we've had this it for a while and it
> | > works well enough. Unfortunately, a carpet fitter today went through a
> | > cable and that sent the alarm system off - tamper mode, i assume. I've
> | > repaired/re-joined the cut wire/cable but the alarm control box still
> | > lights up with with various zone faults. i tried resetting the thing
> | > but still no joy. is there anything else i need to do or try to get
> | > this thing working again? eg, do i have to totally power the thing
> | > down again (disconnect battery and mains?)? I suppose it is possible
> | > that there is some other, as yet, unnoticed damage but can't see that
> | > as the work i had done was only done in one room where only a couple
> | > of yards or so of cable were visible. is there some other code that i
> | > need to input or is there something else that i've neglected to
> | > consider?
> | >
> | > thanks, and best wishes
> | >
> | > mojo
> | >
> |
> |