Re: Telular Telguard TG-1 & TG-4 Service Pricing

["Mark Leuck" <m..leuck@xxxxxxxxx>]

I've been told the AnyNet supports the serial output from the NX-8E although
I don't have any info on it

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:45b6a963$0$10297$815e3792@xxxxxxxxxxxxxxxxx
> Not sure why you'd need serial port.
>
> You're gonna run into similar problem in that Uplink only sells service to
> alarm dealers though.
>
>
> <racerx90@xxxxxxxxx> wrote in message
> news:1169597325.033954.33100@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> | Hmm.. I had a bad feeling about that when I was reading through the
> | documentation at the Honeywell web site (I notice the ECP bus wording
> | but wasn't sure what that meant since I really only know about Caddx
> | systems.) Ideally, I really would like to have a full CID solution (for
> | obvious reasons) - I knew it was too good to be true! Thanks for
> | replying.
> |
> | I'll probably need to look into an Uplink AnyNet solution then. The
> | biggest drawback I see with this approach is not only will I have to
> | buy a NX-584 for a second serial port (since my first one is used),
> | I'll have to build a custom cable to hook them together (unfortunately
> | Uplink doesn't even include a standard serial cable.)
> |
> | At this point I'm almost considering getting a PhoneLabs Dock-n-Talk
> | module and use a regular cell phone with a reduced monthly service plan
> | this way it will run both cellular (if the land line has been cut) or
> | land line (primary). It's sad - I know. ;)
> |
> | On Jan 23, 6:19 pm, " IOW, you lie." <you l...@xxxxxxxxxxxxx> wrote:
> | > On 23 Jan 2007 14:19:28 -0800, racer...@xxxxxxxxx wrote:
> | >
> | > >Does anyone know how the Honeywell AlarmNet 7435-GSM unit would
> | > >interface into the Caddx NX-8e panel? It's not too clear to me how
that
> | > >hook-up would be accomplished (there doesn't seem to be a lot of
> | > >documentation on the Honeywell site on installation information that
I
> | > >could find at least.) Also, would the connection provide full Contact
> | > >ID reporting?You won't get full CID reporting with Alarmnet and a GE
> panel.  It can
> | > only be used in 'zone' mode with panels without a Honeywell ECP bus.
> |
>
>