Re: Strange Phone Line Issue

["nick markowitz" <nick-markowitz@xxxxxxxxxxx>]

Do you have a RJ31x  ESSEX DSL filter
I have found DSL screws with up load down load.tones
and by having the rj block filter it stops it.
Also did they add sattelite dish some times the cable and or dish box has a
phone connection that will screw with phone line as well was this recently
added.
Worse comes to worse take all phones off gray brown telco wires and try
download to see if problem is with in house wiring or comming in from pole .
I have seen DSL cause all kinds of strange problems even when you think you
have everything filtered and some one adds an exstension etc and does not do
it right.
DSC modems are very suseptable to dsl

"ABLE_1" <royboynospam@xxxxxxxxxxxxx> wrote in message
news:9eGdnTRdTcwxgDnYnZ2dnUVZ_segnZ2d@xxxxxxxxxxxxxx
> Had a strange occurrence today with a customers phone line that is still
> un-resolved.  Thought I would share and see if anyone has any hints as to
> what's going on.
>
> Customer has one phone line.
> Standard set up with RJ31X.
> Phone line has DSL
> DSL Filters installed.
> System Communicates Signals to CS, all good
> Normal phones in house with Answering Machine and CID Box
> Previous connection for UpDownload OK.
>
> Problem comes up when I try to connect to panel remotely.  Panel will hang
> and then disconnect.  Went to site today and used my laptop to connect to
> the panel thru my "private phone company in a box" which would be the same
> as connecting over the phone line.  Connection is good and data
> transferred as it should.
>
> Connected my Butt Set to the phone line and dialed with my cell phone to
> trigger the panel to answer, Answering Machine Bypass function enabled.
> While listening to the amplified speaker I heard what sounded like a modem
> answering with a carrier tone after the first ring.
>
> To bring this narrative ahead a bit, I ended up at the demarc and with the
> house, panel and all disconnected so that I was connected direct from the
> CO and the following was observed.
>
> On the speaker of the butt set just before the 1st ring a small buzz click
> was heard and then after the first ring a carrier tone is heard for about
> 1 second and then a pause and then the next ring.  Nothing else is heard
> except for normal rings after that.
>
> It is as if another modem or panel is on the line and connecting on the
> first ring but not answering the call.
>
> Has anyone experienced anything like this and/or what the blazes is it or
> could it be?????????   I ran out of time to investigate it further on site
> with voltages, current, etc. but it seems very strange.  Any thoughts from
> the masses would be welcome.
>
> Thanks,
>
> Les
>
>
>
>
>