Re: NX series

[ssokoly <alarmdude01@xxxxxxxxx>]

ssokoly wrote:
> brent wrote:
>> anyone remember the key punches used at the keypad for direct
>> connecting to panel with a laptop for  GE NX series?
>>
> PC TO PANEL DIRECT CONNECT
> 1. Connect NX-586E to serial port.
> 2. Connect cable with alligator clips to a NetworX panel as
> follows:
> a. Red to POS
> b. Black to COM
> c. Green to DATA
> 3. Start the DL900 Download software.
> 4. Select: PROGRAM ? SETUP ? DIRECT
> CONNECT SETTINGS
> 5. Select the correct port number and baud rate. Protocol
> must be Binary (default). The baud rate should match the
> NX-586E. Default is 9600. Click OK.
> 6. Select the account to use.
> 7. Select DOWNLOAD ? DIRECT CONNECT
> Note: You can also use the tool bar or the [F11] key.
> 8. Download as normal. You cannot perform the following:
> 9. View keypad status
> 10. Enroll devices

1. Attach the cable with the three alligator clips to the proper
terminals on the NetworX panel (Refer to Section 0). Note:
If you have a keypad installed in partition 8, keypad 8, it
must be removed during this operation.
2. On a Partition 1 keypad, enter ? 8
3. Enter the 4- or 6-digit program code (default is 9713).
4. When prompted for the device number, enter 2 5 5 #
5. When prompted for the location, enter 0 #
6. To READ or WRITE:
A. Read (store the NetworX panel configuration into a file
on the NX-586E):
o Enter 1 ?
o Enter the number of the file (1 to 4) in which you
wish to save it
o Enter ? #
o The ?Receiving Data? LED will flash if the command
is being carried out. The keypad sounder will chime
(?ding-dong?) if the operation is successful.
B. Write (copy a file from the NX-586E to the NetworX
panel):
o Enter 2 ?
o Enter the number of the file to copy (1 to 4) ? #
o The ?Sending Data? LED will flash if the command is
being carried out. The keypad sounder will chime
(?ding-dong?) if the operation is successful.
7. A ?triple beep? will sound if any error occurred during either
Read or Write. You can view the result in Location 0 /
Segment 1 (see chart for possible results).