[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Error check list for GEM-P9600 codes
Steve wrote:
> Folks,
>
> Alittle help here. I'm trying to reprogram a P9600 using quickloader. I've read the manuals quite a bit but still having a few issues. During error checking, I've got a code 01333 coming up. They are:
>
> 01333zone1 exit/entry follower requires at least one exit/entry #1/2 and
> 01333zone2 exit/entry follower requires at least one exit/entry #1/2 and
>
> This is for zone 1 and 2 obviously which the zone types are setup as zexit/entry follower telco 1. Why is this error code coming up and how do I correct it? I need them to be exit/entry followers...obviously leaving them as a zburg perimeter telco 1 would remove the codes...I'm not sure where I need to add info?
>
> I wish there was a good example code that could be downloaded to see what I'm incorrect with.
>
> Thanks in advanced!
You don't have any entry delay zones set up. "Entry/exit follower" is
usually a motion sensor that's looking at the entry door. Welcome to
the Land of "Alarm-speak".
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home