Re: Will pet friendly motion detector work with my dog?

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

and...76 lbs is pushing it especially if Rover is active.
when i have a borderline job like this I put Glassbreaks everywhere and only
a couple of pirs.


"Artistry" <fake@xxxxxxxx> wrote in message
news:%hfTg.26104$eW5.11787@xxxxxxxxxxxxxxxxxxxxxxxxx
| Hi:
|
| I am pre-wiring my new house under construction.  I have a 76lbs greyhound
| that will be moving in with my wife and myself.  I am preparing to run the
| 4/22 shielded wire for the 8 motion detectors.  Each bedroom will have one
| motion detector.  My Living room / Dinning room / Kitchen (open floor
plan)
| will have 2 detectors with a ceiling that starts at 8 feet and goes up to
10
| feet.  Every detector's corner has an 8 foot ceilings.  The alarm system
has
| yet to be determined, but all the sensors will be hard wired.
|
| Will my dog likely set off the pet friendly detectors if I mount them up
| high in the corners?  Or, do I have to mount them down low, 3-1/2 to 4
feet,
| to create a "pet ally"?
|
| Is there a particular model detector that would work well up high in the
| corners?
|
| Can I leave the detectors up high and put a mask in them to restrict their
| lower detection?
|
| What do you think?
|
| Thanks,
| John
|
|