Re: Safewatch Pro 2000

[JoeRaisin <joeraisin@xxxxxxxxxxx>]

Tim Taylor wrote:

> "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> news:45183d19$0$10296$815e3792@xxxxxxxxxxxxxxxxx
>
>>inline
>>
>>
>>"Tim Taylor" <fonman76@xxxxxxxxxxx> wrote in message
>>news:IpqdndEnYvDhuYXYnZ2dnUVZ_vOdnZ2d@xxxxxxxxxxxxxxxx
>>| Ok, I was doing a search a while ago trying to find out how to disable a
>>| door sensor and put a motion in its place. I found someone had said to
>>put
>>| in a code and go from there, after powering off the unit. I did as it
>>said,
>>| now there is nothing on the display. It's just used as a local. Any
>>ideas
>>or
>>| help? TIA
>>|
>>| The code is as follows:
>>|
>>| press 1 & 3 at the same time
>>|
>>| press 16*
>>
>>*16* sets the keypad address for the keypad you are working on.
>>
>>|
>>| press * # together
>>|
>>| press #20
>>
>>all this does is read out the installer code if you can see the installer
>>code then you're  ok to program the panel - if you did not see anything
>>after *# then the panel is locked. To be more clear...upon power up after
>>hitting *# the display should say 20, then push #20 to read out the
>>installer code.
>>
>>IF you were able to get to the installer code then change it to something
>>you want...
>>*20  1234 beep (that would change it to 1234...the beep tells you it was
>>accepted)
>>
>>now you have to go to *56...but you *need* a programming keypad to get
>>there
>>(6139 or 6160)
>>then you can follow along in the programming manual and find the old zone
>>you want to change..you'll change the zone type to 04.
>>
>>have you changed to wiring yet?
>
>
>
> Thanks flash. I wasn't real sure what that code was going to do for me, but
> I did find out. I'm completely out of service. When I hold the 1 and 3 down,
> the display will come up 16. When I push anything else it goes blank. I
> guess I've really screwed this one up.
> I couldn't get the installer code BTW.
> Changed to wiring?? Aint following you there.
>
>
>
>

While it is likely that your system needs its keypad to be at address
16, it may be an older one and will like 31 better.

In order to change that you have to press 1 & 3 within 30 seconds of
applying power to the keypad.

Easiest way is just like you did it the first time only use 31 instead
of 16.

holding down the * # keys has to be done within 50 seconds of applying
power to the system.  So you will probably have to go through the "power
off... power on" sequence a few times.

Good Luck