Re: Safewatch Pro 2000

["Tim Taylor" <fonman76@xxxxxxxxxxx>]

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:45183d19$0$10296$815e3792@xxxxxxxxxxxxxxxxx
> inline
>
>
> "Tim Taylor" <fonman76@xxxxxxxxxxx> wrote in message
> news:IpqdndEnYvDhuYXYnZ2dnUVZ_vOdnZ2d@xxxxxxxxxxxxxxxx
> | Ok, I was doing a search a while ago trying to find out how to disable a
> | door sensor and put a motion in its place. I found someone had said to
> put
> | in a code and go from there, after powering off the unit. I did as it
> said,
> | now there is nothing on the display. It's just used as a local. Any
> ideas
> or
> | help? TIA
> |
> | The code is as follows:
> |
> | press 1 & 3 at the same time
> |
> | press 16*
>
> *16* sets the keypad address for the keypad you are working on.
>
> |
> | press * # together
> |
> | press #20
>
> all this does is read out the installer code if you can see the installer
> code then you're  ok to program the panel - if you did not see anything
> after *# then the panel is locked. To be more clear...upon power up after
> hitting *# the display should say 20, then push #20 to read out the
> installer code.
>
> IF you were able to get to the installer code then change it to something
> you want...
> *20  1234 beep (that would change it to 1234...the beep tells you it was
> accepted)
>
> now you have to go to *56...but you *need* a programming keypad to get
> there
> (6139 or 6160)
> then you can follow along in the programming manual and find the old zone
> you want to change..you'll change the zone type to 04.
>
> have you changed to wiring yet?


Thanks flash. I wasn't real sure what that code was going to do for me, but
I did find out. I'm completely out of service. When I hold the 1 and 3 down,
the display will come up 16. When I push anything else it goes blank. I
guess I've really screwed this one up.
I couldn't get the installer code BTW.
Changed to wiring?? Aint following you there.