Re: 7845C in conjunction with a DSC 5020

["Roland Moore" <roland@xxxxxxxxxxxx>]

You might want to remember where that was so you (or someone) can replace
the 7845C with the G model in a year or so.
It would be unusual to have DSC and Honeywell together because (as Jim Rojas
already mentioned) for maximum reporting abilities you need the same
component brands together.
"Ratchet442" <ratchet442@xxxxxxxxxxxxx> wrote in message
news:mYVah.4862$1s6.2285@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Seen this once a long time ago in a mini-mart. The mini-mart had a DSC
> 5020 and a Alarmnet 7845C tied into it, but at the time I was unable to
> locate where in the mini-mart the 7845C was located to verify how it was
> wired. When I sent some signals, I expected to be told by monitoring that
> they recieved a signal from the panel in CID ie:(Zone 4). I then expected
> to get a typical Zone 1 Burg Alarm off of the 7845C. What I got was a
> (Zone 4) off of the 7845C. I then questioned how they got a (Zone 4). It
> seems that both the panel and the 7845C were setup using the same alarm
> event template. Which tells me, that the 7845C was setup with some type of
> communications between the 5020 and 7845C. And was not wired in the
> traditional method of (panel output-to-radio input). I assume this was
> done using a street smart module. Anyone got an idea how this may have
> been wired in order for the 7845C to understand the system events enough
> to report CID. Thanks, Ratchet!
>