clifford car alarm install help

["elvisap" <elvisap@xxxxxxxx>]

installing in a Mercedes sprinter

does anyone know where this wire goes to for the indicators to flash.

White/red light flash input - this wire is the input for the on-board dual
light flash relay. if the vehicle has positive parking light activation
wires, connect this wire to a constant (+) 12v source that is fused at 15a
or higher (if the vehicle parking light activation wire is negative, connect
this wire to a chassis ground.

if I put it to the positive to the indicators

then where do I put the two white wires

white parking light output - these wires are output of an on-board dual make
relay and should be connected to wires in the vehicle that control the
parking light wire polarity. if the vehicle's parking lights are controlled
by a single wire connect both white wires.

thanks for the help.