Re: Installer code lockout after power-down on ADEMCO 50P

[G. Morgan <alarmpro@xxxxxxxxxxx>]

On 6 May 2006 12:12:53 -0700, mthomas@xxxxxxxxxxx wrote:

>Hi,
>
>A few years back I did a DIY install of an Ademco 50P.
>
>In the process of adding new devices this morning I got lost in the
>programing menu and cound not back out, so I powered down the panel
>(disconnected the power and batteries for about 30 seconds)  then
>powered it back up.
>
>The panel came back up as ready to arm, but would no longer accept the
>instaler code to enter the programming mode, arm the system, or
>anything else - I can arm and disarm the system via a user code, it
>reports fault conditions and all the changes I made prior to the
>power-down seem to be in effect,  it just does not respond in any way I
>can discover to the instaler code.
>
>Any suggestions?


1> Power system down (wait 1 min. or so)
2> Power system up
3> within 50 secs. goto keypad and hold down "*"  & "#"
4> you should be in programming now, goto *20 enter your *new*
installer code hit * ,  then *99 to exit programming



--

   ___           _
  / _ \_ __ __ _| |__   __ _ _ __ ___
 / /_\/ '__/ _` | '_ \ / _` | '_ ` _ \
/ /_\\| | | (_| | | | | (_| | | | | | |
\____/|_|  \__,_|_| |_|\__,_|_| |_| |_|