Re: dsc power 832 bell operation

["alarman" <alarman2000@xxxxxxxxx>]

"Keith" <ckhurst@xxxxxxxxxxx> wrote in message
news:1153537286.066998.312140@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>I have installed a dsc power 832 system in my home as it was built.
> Now I am attempting to program the system and all is well so far, but
> when I connect the "bell" circuit to my indoor siren, it produces a low
> volume churp which I can not figure out why or how to turn off.  It
> does not time out based on the bell timer and I show no alarms on the
> panel.  I did not install any resistors in the circuit.  Any ideas??

That panel supervises the bell circuit with a very low voltage. Place a 1K
ohm resistor across the siren terminals.
js