[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: System Sensor/DSC problem

Subject: Re: System Sensor/DSC problem
From: Robert L Bass <sales@xxxxxxxxxxxxxxxxxxxxx>
Date: Sun, 05 Feb 2006 03:15:14 -0300
Newsgroups: alt.security.alarms
References: <IB9Ff.75736$QW2.59394@dukeread08>

The panel maintains a low voltage output across the alarm output
terminals in order to supervise the wiring to the siren.  Install
a 1000 Ohm resistor across the terminals to sink the voltage and
the siren will remain quiet until an alarm is triggered.

--

Regards,
Robert L Bass

Bass Burglar Alarms
The Online DIY Store
http://www.BassBurglarAlarms.com

On Sat, 4 Feb 2006 16:08:30 -0800, "Jimmy Dale Reeves"
<jimmydale@xxxxxxxxxxxxxxxx> wrote:

> I am using a SS Mini-alert sounder PA400 series as an inside siren for a DSC
> 5010.  When I hook it up, it emits a high tone pitch while not in alarm.  I
> have used this same siren with a DSC 155mx and have had no trouble. This is
> the second panel that it has happend on. Could anybody help me?

References:
- System Sensor/DSC problem
  - From: Jimmy Dale Reeves

Prev by Message: Re: Who wants a donut?
Next by Message: Re: vonage 911 service
Previous by thread: System Sensor/DSC problem
Next by thread: Re: System Sensor/DSC problem
Index(es):
- Message
- Thread

alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home