Re: Missing Zones/Caddx NX-8e

["Chub" <w@xxxxx>]

"Nick" <pn.damico@xxxxxxxxx> wrote in message
news:1140324141.793746.287880@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>I have a Caddx NX-8e with two 216 expander cards.  One 216 is fully
> populated with no issues.  The other card has half of the zones
> populated with the remaining zones jumpered with a resistor.
>
> I added a zone tonight.  The zone was working fine; it is 33.  After a
> little while, 33 and 34 are missing when I look at the zone status on
> the keypad.  Zone 33 is connected to the device; EOL resistor at the
> device.  34 is jumpered with an EOL resistor.
>
> No matter what I do, I cannot get 33 and 34 to show back up.  Even if I
> remove everything from these zones, they do not display.  I tried to
> use a different common port; still nothing.
>
> Any ideas -- do you think the 216 card is fried?  I did double-check
> the dip switch settings, 1 and 2 are on; the remaining are off.
>
> Thank you.

could it be you have the zone nulled in programming?  If there is a zero [0]
in 'partition select' it will null zone out of existence