Re: Help with Fire Fault on Ademco Lynx-R

["Jack" <jack@xxxxxxxxxxxxx>]

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:458b3259$0$25784$815e3792@xxxxxxxxxxxxxxxxx
> code+off, code+off should clear it.
>
Crash Gordon, I did give that a try, but it did not get rid of the problem.
So after reading the manual and taking a very deep breadth, I entered my
Installer Code + 800 *56. I then kept hitting the * key until I got to zone
20 and when "b" popped up I entered 00, which then jump me to option F. I
then entered 1 to confirm my previous entry and then pressed * *. I thought
the key commands to get out of programming mode was *99. After pressing *99,
the keypad would not let me exit programming mode. I had to disconnect my
power cord from the wall and I then took off my panel cover. This shut down
the system and after waiting for several seconds the system came back up
with the wrong time on the panel. Everything else seems to work. I have
tested a few doors and windows and the system has not faulted in 30 minutes
since the change to zone 20.

Can someone explain what I did wrong when trying to exit *56 Mode?

I'll read the manual to determine how to set the clock to the correct time.
Enough for one day.