Re: DSC 832

[Frank Olson <Use_the_email_links@xxxxxxxxxxxxxxxxxxxxxx>]

gipdc wrote:
> Hi, I have just finished wiring DSC 832 basis system together.  There
> is only one PIR sensor.  I am having trouble activating the system..
> i.e., arming it.  I think that my wiring installation is correct..  I
> am unable to get the system to be in the ready state to arm the system.
> I did the supervision part of the programming ... showing 8 on the LCD.
>  This is the location of the Keypad.  I don't know if it is sensing the
> PIR sensor.   Any help would be great.
>


1.  Write down how you've wired each zone of your panel.  You should
list the zone number and the device it's attached to:

For example:

Zone 1     Entry door
Zone 2     PIR
Zone 3     Kitchen door
....
Zone 8     ???



2.  Enter installer programming by pressing * then 8 then the installer
code.

2.  Enter 0, 0, 1 and program each zone using the suggested response
type in the programming manual.

01 - Entry delay door
04 - Motion sensor
03 - Perimeter zone (window contacts, glass breaks, etc.)
00 - for any unused zone.

Press #, then # again.  If you've decided to use End of line resistors
and haven't changed the parameters from the default, your keypad should
read "ready".  If you aren't using the supplied end of lines, then
you're going to have to change the zones from "supervised" to "normally
closed loops".

Read the manual!!