Re: Wizard IIe /Napco 1632

["Bob La Londe" <usenet@xxxxxxxxxxxxxxxxx>]

"Robert L Bass" <sales@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:iv9l32h160p0mf6giemnt1b37m6hnommsj@xxxxxxxxxx

> Have you configure the Wizard IIe as keypad #1?
>

I never had to do that on any panels.  In fact becasue I liek to leave KP1
for programming on site I would never put the wizard on one.

I can think of a couple things.  First off.  There are two codes for a
wizard.  The wizard code, and then the user code you have programmed into
the panel.  You can set the wizard to use or not to use the wizard access
code.

The other thing that comes to mind is whether or not you have assigned the
wizard to an area.  It assigns just like any other keypad.

Although to be honest the description of your problem doesn't seem to make
any sense.

>
> > I can't seem to arm my system through the Wizard IIe. All other
> > functions work disarm,control outputs 1-3, reset, etc. When I attempt
> > to arm, I get "invalid disarm code". Any ideas? I am setup as keypad
> > id=002 and keypad type in the 1632 is set to "wizard"
> >
> > Thanks in advance!
>
>
> --


*** Free account sponsored by SecureIX.com ***
*** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com ***