Re: NAPCO NO LONGER REPLACING KNOWN DEFECTIVES

["Russell Brill" <russwbrill@xxxxxxxxxxxxx>]

"Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
news:MMydnSHFs_73ZKDenZ2dnUVZ_tOdnZ2d@xxxxxxxxxxxxxx
>
> "Russell Brill" <russwbrill@xxxxxxxxxxxxx> wrote in message
> news:1Bl%e.5185$zQ3.555@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Bob,
>>
>> When programming any of the Napco Gemini panels to use Ademco Point ID,
> what
>> value do you enter in locations like keypad Panic... Is it like the old
>> Moose stuff, enter any value in the reporting location to enable
>> reporting
>> in Point ID, leave blank if reporting is NOT desired... Regards, Russ
>
> You can enter anything for reporting other than zones
>
>
I know I must choose Burg, Fire, Heat, Gas, etc. etc... when it comes to the
zones... The manual is a little confusing when it comes to sending things
like "Keypad Panic", there isn't a Point ID choice available... Soooo, I'm
assuming if I enter any value (Like "11"), the panel will send a E120 signal
to the CS... If I don't want to send a "Keypad Panic", I would leave that
entry blank........ Mark is this correct???

Regards,
Russ