Re: Firelite Power problems (in general)

["Rocky_T_Squirrel, Esq." <gafa_usa@/nospam\hotmail.com>]

Sorry Mike,  my book must be too old.  MS-4424  doc # 15153 ECN-95-067
This book specs. Maximum charging circuit 27.6v 1.5amp

the book for MS-4424B doc # 15125  ECN 95-354
specs. maximum charging circuit 27.6v 1.5 amp

the logic seem reasonable to me if your using 24 volt battery load a
charging level
of 25-27vdc would keep the bats charged but not boil out the gel.
yet still high enough to recharge after a drain within the 24-36 hour
limit..

RTS



"Mike Sokoly" <secure15@xxxxxxxxxxxxx> wrote in message
news:iKz9f.37715$rE2.300@xxxxxxxxxxx
> Check page 48 of the MS 4424 Installation Manual:
> Table 4 Troubleshooting:
>   "Power Touble LED ON";
> "Battery Trouble/Battery LED ON";
> "Remove Batteries,
>   "Check Voltage across charger output (17-19V!)"
> "Otherwise replace circuit board"!
> Mike S
>
>
> Rocky_T_Squirrel, Esq. wrote:
> > 17-19vdc    for a 24vdc panel?
> > I think  I'd give the tech an email and ask for a detailed explanation
for
> > that voltage reading..
> > tks,
> > RTS
> >
> >
> > "Mike Sokoly" <secure15@xxxxxxxxxxxxx> wrote in message
> > news:Jod9f.31073$rE2.21973@xxxxxxxxxxx
> >
> >>Thanks Rocky,
> >>Noted that in the Install Manual 17-19VDC was within the "normal" Range!
> >>What's up with that?
> >>OF COURSE...... What did I get when I Checked THAT particular PANEL?
> >>HMMMMM...... 19VDC! Will try the reset trick on it!
> >>Mike S
> >>
> >>
> >>