[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Troubleshooting Question

Subject: Re: Troubleshooting Question
From: "Robert L. Bass" <robertlbass@xxxxxxxxxxx>
Date: Fri, 17 Jun 2005 10:22:38 -0400
Newsgroups: alt.security.alarms
References: <ZQAse.1870$Nz2.84@xxxxxxxxxxxxxxxxxxxxxxxxxx>

J P Shull III wrote:
>
> 10-20 openings on one zone.  Intermit falsing.

What kind of detectors are in the problem zone?  If you have more than one
detector in the loop you may need to separate them to find the problem unit.
What is the total resistance of the total loop?  Check with an Ohm meter.

If the wiring is OK, you'll need to test each detector.  The procedure
depends on the type and model of detector(s) in the loop.  If you post what
you're using I can give more specific instructions.

--

Regards,
Robert L Bass

=============================>
Bass Home Electronics
2291 Pine View Circle
Sarasota · Florida · 34231
877-722-8900 Sales & Tech Support
http://www.bassburglaralarms.com
=============================>

References:
- Troubleshooting Question
  - From: J P Shull III

Prev by Message: Re: FAI Security Gurard 111
Next by Message: Re: sensor choice for "gong detect"? & invisible light switches
Previous by thread: Troubleshooting Question
Next by thread: Re: Troubleshooting Question
Index(es):
- Message
- Thread

alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home