Re: Programming problem on Vista 20P

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

"Crash Gordon®" <NONE@xxxxxxxx> wrote in message
news:PBjbe.83$pc.17439@xxxxxxxxxxxxxxxxxx
i had a check 100 saturday (6150rf)...defaulted the keypad and reset it to
addr 16 and went away...but i wasn't using buttons.

their manuals are getting better though.


The manual doesn't show this tho, many times when exiting RF keypad
programming you will get a check 100, in those cases entering then exiting
panel programming clears that up. Older 6150RF keypads had problems with the
tamper switch which is why they deleted that on later versions. If he's
getting a check 100 then it's going to be one of the following

1. He doesn't have his receiver set at address 100
2. He doesn't have a receiver period
3. He's got an older 6150RF keypad with a bad tamper
4.
5. He's got a defective RF keypad

I've worked with these panels hundreds of times and thats pretty much all it
could be, I'd default the RF keypad and start over if I were him :)