is X10 2-way ?

[Tolga Uzuner <tolga@xxxxxxxxxxx>]

Hi There,

I am new to the group. I've reda a lot of helpful material here, so
thanks to everyone already.

I am wiring up a brand new house, and would like to install controls
into all the electrical circuitry so that I can do the following:
- turn any circuit on or off
- monitor IF a circuit is being used ot not i.e. if it is passing
current or not
- write macros to turn circuits on and off contingent on signals from
motion detectors etc.
- control/monitor circuits and also motion detectors over the web

Reading up on X10, it appears some of this is possible but I am not sure
if one could actually use x10 to check if current is running through a
circuit. Is this possible ? Do socket controls exist in x10 which can
also act as transmitters contingent on something happening ?

I do not want all the circuitry inside the socket, and not an external
plug. I am wiring the house new, so might as well put in circuitry into
the sockets now which will give me what I want.

If X10 is not a solution, what of something like Insteon or Zigbee  ?
Can I install Insteon into the sockets internally and get the behaviour
I need ?

Finally, I am in continental Europe... are there Insteon/Zigbee products
available in Europe ?

Thanks, Tolga