Re: Homevision Help

["Frank Mc Alinden" <fmcalind@xxxxxxxxxxxxxx>]

Hi Glen
If you want to say when a certain w800  x10 command is
captured  by xPL and you want to run a macro in Homevision ...just simply
hightlite the x10 command in the xPL monitor display and right click then
select create Determinator..this will walk you thru this....Have a look in
the photo section of xPL Yahoo  that might help......The automatic creation
of a Determinator creates the input section and you only need to add the
output section ie Homevision macro.....
Just yell out if you need more help
Frank

----- Original Message -----
From: "kirstglen1" <glen.ferguson@xxxxxxx>
To: <ukha_xpl@xxxxxxx>
Sent: Saturday, March 19, 2005 6:20 PM
Subject: [ukha_xpl] Homevision Help


>
>
> Hi all,
>
> I am quite new to all of this Xpl stuff and was hoping someone could
> give me some help. I have Homevision pro and a W800RF plugged into
> my computer. I have configured them all as devices and the Xpl
> monitor sees the X-10 commands from the W800. I am not sure how to
> configure HV to receive these commands. The documentation talks
> about inputting the hvx file but I don't know to do this except
> throught the X-10 import function which I have already done. (by the
> way sending commands through this also does nothing). I have xpl.ocx
> running and HV running at the same time. I only have one serial
> interface through Com2 to HV. Is this how I am supposed to do it? Do
> I need to configure this?
>
> Please help
>
>
> Thanks Glen
>
>
>
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
> Yahoo! Groups Links
>
>
>
>
>
>
>



xPL Links: http://www.xplproject.org.uk http://www.xplhal.com http://www.xpl.myby.co.uk
To Post a Message: ukha_xpl@xxxxxxx
To Subscribe:  ukha_xpl-subscribe@xxxxxxx
To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx