The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: xPL cm11 Service


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Schema for FirM



Hi All

Im reworking my xPL-FirM and was wondering if  im using the correct
schema....
Only 2 commands can be sent to FirM Hardware.

1: Zone Transmit Command ...which informs FirM which ir zone to setup for
ir
transmission..

2:  Zone Receive Request....which requests from FirM which ir zone has the
most recent received signal came from...........

Currently what i have been using  is a special schema called FirM.Basic

so a transmit command would be for example..

FirM.Basic
zone=3

and a Zone Recieve Request would be as follows

FirM.Basic
command=Request

Is this ok ??? Or should i be implementing some form of Control.basic...??
If so could someone please provide some samples for tx and rx ....

Thanks
Frank






www.armaghelectrical.com.au




xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.