[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: Re: T.O.M 10
Try taking the power off the board and reapplying it. Then check to see
if the bottom box on the app show the TOM10 boot up message
"TOM10 Ver1.4 Copyright JM Earl"
This box is showing the incoming messages from the board so will show
whether the serial port is open and linked to the app.
S.
Frank Mc Alinden wrote:
> Hi Steve
> The looping problem appears to have been fixed .....I have
set
> the poll rate to 30 (for testing) which i assume is 30 seconds and
its not
> reporting the zone temps ,also tried sending an xpl command message
but
> no reponse from the app...Although i am getting hbeats from it ok...??
>
> Frank
>
>
> ----- Original Message -----
> From: "Steve Cooper" <scoop@xxxxxxx>
> To: <ukha_xpl@xxxxxxx>
> Sent: Sunday, November 21, 2004 9:47 PM
> Subject: Re: [ukha_xpl] Re: T.O.M 10
>
>
>
>>>I too am getting the same problem as Frank..
>>
>>I've change some of the error handling round a bit. Do you want to
give
>>the latest version a go. Should be v0.2.
>>
>>Probably worth deleting the source.cfg files to make sure you get a
new
>>instance to start with.
>>
>>S.
>>
>>
>>
>>xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
>
> http://www.xpl.myby.co.uk
>
>>To Post a Message: ukha_xpl@xxxxxxx
>>To Subscribe: ukha_xpl-subscribe@xxxxxxx
>>To Unsubscribe: ukha_xpl-unsubscribe@xxxxxxx
>>Yahoo! Groups Links
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe: ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe: ukha_xpl-unsubscribe@xxxxxxx
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
>
xPL Main Index |
xPL Thread Index |
xPL Home |
Archives Home
|