[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: Trouble getting flags set in HV - I found it!!
- Subject: Re: Trouble getting flags set in HV - I found
it!!
- From: "gmotichka" <gmotichka@xxxxxxxxxxxxx>
- Date: Fri, 10 Dec 2004 20:43:19 -0000
When I re installed the w800 service after mal incorporated the
delay,I know have two instances of a sourec in the dropdown box.
The one I had picked was not the correct one. Once I picked the
correct one it acted as expected.
So how do I get rid of the non active instance in the drop down box?
George
--- In ukha_xpl@xxxxxxx, "gmotichka" <gmotichka@h...>
wrote:
>
> Yes, Absolutely sure it is enabled.
>
> Frank
> I've also tried both combinatins of case - all caps, first cap,
no
> caps.
>
> I appreciate you guys scratching your heads on this. Do you think
it
> couls have anything to do with the delay mal put into the w800?
>
> George
>
>
>
>
>
>
> --- In ukha_xpl@xxxxxxx, "John B"
<home-automation@j...>
> wrote:
> > Hi George,
> >
> > > When I was relaying what was on the condition screen, I was
> typing
> > > it in so yes it was a misprint. Here is exactly what ther is
as
> > > pasted from the boxes:
> >
> > I think Frank may have mentioned this before, but have you made
> sure the "This determinator is enabled" check box is ticked?
> >
> > The "Execute Now" menu item will always work, even if a
> determinator is not enabled, however it will only act upon it's
> input conditions if it is enabled.
> >
> > Regards,
> >
> > John
xPL Main Index |
xPL Thread Index |
xPL Home |
Archives Home
|