trying to send to my slimp3. xplsend doesn't allow me to send a
"\n".
trying this:
xplsend xpl-cmnd SLIMDEV-SLIMSERV.1 osd.basic command=write text=\nxyz
it doesn't work though. nothing show up on my slimp3. is there
special syntax for sending control characters?
thanks
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.