The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: xPLHal scripting matches


  • Subject: Re: xPLHal scripting matches
  • From: Doogie Brodie
  • Date: Thu, 11 Sep 2003 10:06:00 +0000

Ian Lowe wrote:
> At present, x10 control via xPLHal and the CM12 is orders of magnitude
> faster than Homeseer was: I'd hate to lose that when, for all intents
and
> purposes, the script engine in it's current form isn't limiting me at
all!

Hi guys,

Just on this note, I'm looking at replacing Homeseer with xPLHal - I've
played around a little bit with xPLHal so far but nothing much.

Is there an easy way to send a discreet dim level to a device that
doesn't support extended commands? (specifically an LW11) ie When my PIR
triggers in the kitchen I want to do a quick time check, quick check on
gone to bed flag, and then either dim to 80% or 40% (without dimming up
to 100% then back down so when I keep triggering it, it doesn't go 80,
100, 80, 100, 80 etc), not 80% of the current level.

I might have missed something obvious... like I did with the Tivo hub
loopback thing, which all works fine now :-)

--
Doogie






xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.