[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: Re: TOM10 xAP Connector
> I know weve spoken offlist but i think the relevent key/value pair
> should just be omitted. However any app reading that sensor wouldn't
> pick up any data and n/a might be more useful
>
> BSC will be a great schema for this too Stuart but you will need to
> set the 'hysteresis' of the temp changes before xAPBSC.event
> messages are sent and also a frequency of events I guess. Looking
> forward to seeing this.. A config message would do this. In an even
> more sophisticated implemenation then threshold 'alarm' levels would
> be used to trigger an appropriate message. In BSC missing sensors
> would just not have a corresponding sub address present.
Ok, here's the output from the latest incarnation of the tom10 connector,
based around Stuart Grimshaws proposed 1wire schema. I'll start looking at
using BSC next......
xap-header
{
v=12
hop=1
uid=FF000200
class=1wire.temperature
source=qubiq.tom10.Group1
}
1wire.device.1
{
temp=20.00
device=87443C000000h
}
1wire.device.2
{
temp=NA
device=NA
}
1wire.device.3
{
temp=NA
device=NA
}
1wire.device.4
{
temp=NA
device=NA
}
1wire.device.5
{
temp=NA
device=NA
}
1wire.device.6
{
temp=NA
device=NA
}
1wire.device.7
{
temp=NA
device=NA
}
1wire.device.8
{
temp=NA
device=NA
}
1wire.device.9
{
temp=19.93
device=98C068000000h
}
1wire.device.10
{
temp=NA
device=NA
}
xAP_Development Main Index |
xAP_Development Thread Index |
xAP_Development Home |
Archives Home
|