Re: Compaq R3000h UPS

["Andy" <andywhitfield2002@xxxxxxxxxxx>]

I wouldn't advise adding a good batt set in parallel.
You need to sort out batts individually.
Andy the UPS Man

--- In ukha_d@xxxxxxx, "domdevitto" <dom@...> wrote:
>
> I think I had this happen - I think it's a battery-too low condition,
bas=
ically the circuits think the battery is dead.
>=20
> If you take the batts out and charge them elsewhere, or add a full
batter=
y in parallel, you can probably get the charging circuit to kick in and
tak=
e over again.  The batts are probably fine, but this kind of deep cycle
isn=
't healthy.
>=20
> Dom
> --- In ukha_d@xxxxxxx, "Malcolm" <malcolm@> wrote:
> >
> >=20
> > my UPS has been idle for a couple of months but at the weekend I
finall=
y got some time to make some room for it my new rack.  However on powering
=
it up I'm not getting any sense out of the flashing lights on the front
pan=
el. Basically every light is flashing on then off avery few seconds which
d=
oesn't correspond with anything in the manual. I've left it powered up for
=
24h+ now but no difference.=20=20
> >=20
> > My usual answer to this is replace the batteries but they're
=A3200 whi=
ch makes me a little uncomfortable with a such a "trial and
error" fix.
> >=20
> > Any ideas?  TIA
> >=20
> > Malcolm
> >
>




------------------------------------

<*> Join the Automated Home Forums
http://www.automatedhome.co.uk/vbulletin/