Re: Comfort Design Question

[Ben McCormack <yahoogroup@xxxxxxxxxxxxxxxxxxx>]

Martin

I dont think the lem03 can be used in a slave unit or in a system with
slave units

'LEM03 CANNOT be used with any system containing Slave Expansion
panels (SEP02's).'

'LEM01's connect within the Comfort Panel or SEP02 via short ribbon
cable, they CANNOT be remotely sited. Each output can deliver 100 mA
up to a combined auxilliary current of 1.35 Amp. '

Ben

On 30 May 2008, at 11:23, Martin McCreesh wrote:

> Ben,
>
> I am also exploring comfort and saw the same restriction but I think
> when you add the slave device in the future you could move the lem03
> into the slave - not sure if my understanding is correct there.
>
> Martin
>
> ----- Original Message -----
> From: Ben McCormack
> To: ukha_d@xxxxxxx
> Sent: Friday, May 30, 2008 7:38 AM
> Subject: Re: [ukha_d] Comfort Design Question
>
> Ben
>
> As far as I can see if I add an LEM03 I cannot at a later date add any
> further Slave Expansion. Have I got this right? The LEM03 leeds me
> into a dead end!
>
> Ben
>
> On 30 May 2008, at 00:50, ben addison wrote:
>
> > Hi ben,
> >
> > All the parts you list below can fit into the comfort panel.
> >
> > Comfort can have extra zone by using a lem03, which plugs into
the
> min
> > board.
> >
> > If you need more help just ask me.
> >
> > thanks
> >
> > Ben Addison
> >
> > Ben Addison Ltd (electrical Contractors)
> >
> > 07889845712
> >
> > www.benaddison.com
> >
> > _____
> >
> > From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On
> > Behalf Of
> > Ben McCormack
> > Sent: 29 May 2008 20:55
> > To: UKHA Mailinglist
> > Subject: [ukha_d] Comfort Design Question
> >
> > Hi All
> >
> > I am just about to place an order for my Comfort system.
> >
> > The plan is to install Comfort in a central location and run all
> > wiring back to this point and I am looking to purchase the
following
> >
> > Comfort Gen 2 Untra II Panel
> > Backup Battery
> > KP04 Main Keypad
> > Door Phone
> > Phone Protection Board
> > CBUS Interface
> > Ethernet Module - UCM01/ETH
> >
> > Now what is not obvious to me is how all the part physically fit
> > together. Can all the above be located in the Main Panel?
> >
> > Now thinking about zones
> >
> > Initially I will need about 10 zones but this may increase over
time
> > if I put magnetic sensors on each window. So I will need to add
> extra
> > zones.
> >
> > So what is the best way of doing this.
> >
> > Do I go for a Slave Expansion Panel? Or Unibox?
> >
> > I am confused about this, can anyone help?
> >
> > Regards
> > Ben
> >
> > [Non-text portions of this message have been removed]
> >
> > [Non-text portions of this message have been removed]
> >
> >
> >
>
> [Non-text portions of this message have been removed]
>
> [Non-text portions of this message have been removed]
>
>
>



[Non-text portions of this message have been removed]


------------------------------------