The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: AD10 problem


  • Subject: RE: AD10 problem
  • From: "Ian" <ian.bird@xxxxxxxxx>
  • Date: Thu, 20 Sep 2007 11:11:55 +0100

In days of old I had on of these and it failed in much the same way.
Turned
out there was an actuating arm inside that was made of plastic and it had
broken in two. There was still the click as the magnets energised but the
main conductor was not sliding across hence no output change. Mine stuck in
the on position and since it was the kitchen lights was rather obvious. An
LD11 now sits in its place ;-)

Ian

> -----Original Message-----
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx]On Behalf Of
> Tim Hawes
> Sent: 20 September 2007 09:22
> To: ukha_d@xxxxxxx
> Subject: Re: [ukha_d] AD10 problem
>
>
> It's just a quiet click and not at all like the clunk I get from the
> plug-in modules :-(
>
> Cheers,
>
> Tim.
>
> On 9/20/07, Phil Harris <phil@xxxxxxx> wrote:
> > TBH it sounds knackered - you'd usually hear quite a hefty
> clunk switching
> > on or off.
> >
> > Phil
>
>
>
>
>




UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.