Re: Need advice: connecting sonos zone player through mains lan adaptor

["keyvan2r" <keyvan@xxxxxxxxxxxxx>]

I did have the player connected by wire and it worked fine and was
visible on all remotes. I since moved it to the new position and it
was not visible on any remotes. Tried a reset but no joy!

--- In ukha_d@xxxxxxx, Neil Fuller <neil.fuller@...> wrote:
>
> Keyvan
>
> Have you tried this non communicating player in a wired position?
i.e,
> swap non communicating one with one the wired player?
>
> I went 'round in circles trying to sort out two ZP100's that
wouldn't
> talk wirelessly. Eventually, I put them in to wired locations and
they
> still wouldn't talk. Turned out both were faulty - Not too
impressed
> with the 50% failure rate although they have been OK since they
were
> exchanged under warranty and all 4 are chatting away merrily now :-)
>
> Regards
>
> Neil
>
> keyvan2r wrote:
> >
> > I need to install a zone-player in a room which has no cat5
point. Most
> > of the house is wired, but not this room. I have tried to get it
> > working wirelessly, and it won't!! Even though the other wired
player
> > is 40 ft down the corridor!
> > I was wondering if all attempts at wireless connection fail, does
> > anyone know if I can use a pair of those mains-plug lan adaptors
to
> > connect it to my ethernet hub? Like along piece of cat5 :-)
> > If yes.. then which is the best/right one to buy?
> > Any advice would be most appreciated.
> >
> > Thank you.
> >
> > Keyvan
> >
> >
>