CBUS assistance

[Adrian <yahoo1@xxxxxxxxxxxxxx>]

Hi

trying to get this to work with no success

I have 2 groups setup for 2 channels on a dimmer unit (say group 1 and
group 2)

these are controlled fine by a switch (switch 1 dimmer for group 1,
switch 2 dimmer for group 2)

What i'm trying to configure is a separate switch elsewhere which will
either turn both these lights off or on.

I configured on the dimmer a new group which had group 1 and group 2
selected (call it group 3)

now when I configure a button for on/off , i get some very different
results.
if both group 1 & 2 are off or on, it all works fine, i can turn both
lights on/off via group3
where it stuffs up is if say group 1 is on, it then turns on group 2 ok
but when turning off, it only turns off group 2 and leaves group 1 on

Am i missing something, is this possible?

Adrian





** Sponsored by http://www.BERBLE.com **
all the Cool Stuff, in one Place