The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: Anyone used "Home Wireless Monitoring System Alarm VP1000"


  • Subject: RE: Anyone used "Home Wireless Monitoring System Alarm VP1000"
  • From: "Craig" <craigc.lists@xxxxxxxxxxxxxx>
  • Date: Thu, 6 Jul 2006 14:38:25 +0100

> to be notified of an alarm condition, obviously you do.  Very
> easy to set up, and there is an X10 interface that you can
> get for it, but I have yet to explore that route (sorry Craig ;)).

The VP1000 is actually rebadged PowerMax+ hardware, as the internal pcb is
labelled 'Visonic PowerMax+'.

To 'enable' the X10 on the VP1000 you will need a 'PowerMax+ rs232 adapter'
and a special VP1000 config file to load onto the VP1000. I purchased this
as a 'kit' from a previous SmartHome show a year or so ago.

The VP1000 will then need to be connected to a XM10U (not CM12U), my
current
setup is:

VP1000 -> XM10U -> CM12U -> Homeseer

BTW- I was pleasantly surprised at the wireless range of the PIRs to the
panel (better than the WiFi range in my house).

However, the one thing Im not looking forward to is replacing all the CR-2
batteries in the PIRs when they fail, could work out quite expensive. If
anyone knows a good bulk source of these batteries please let me know.






UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.