Re: Smoke Detector Help

[Neil Fuller <neil@xxxxxxxxxxxxxxxxx>]

Stuart

You could try calling the ESP technical help line - The number is on the
first page of the datasheet. I'm sure they would be able to tell you
exactly what happens when there is a fire detected.

Regards

Neil

Stuart Billinghurst wrote:

>I have some standard Fire alarm smoke detectors and rise of head
>detectors,
><http://www.tlc-direct.co.uk/Technical/DataSheets/ESP_Fireline/CSD-1.pdf
>
>
>http://www.tlc-direct.co.uk/Technical/DataSheets/ESP_Fireline/CSD-1.pdf
>These are 24v units.
>
>I've had no previous experience fitting smoke detectors and thus am not
>sure how to interface them to the smoke detector circuit on my burglar
>alarm and into homevision, basically I plan to build a module to go
>between the smokes ring with Indicator lamps (Upstairs, Downstairs and
>Workshop) and give a set of Dry contacts for connection to the alarm
>system and to HV, I must admit I was expecting to find + and - and a
set
>of contacts but just appear to have + and - in / out, so following a
lot
>of goggling and turning up not a lot I was hopeing that someone here
>would be able to point me in the right direction: I am wondering what I
>should be looking for in a way of an alarm signal / Fault signal and if
>anyone can point me in the right direction?
>
>
>Many thanks,
>
>Stuart.
>
>
>
>[Non-text portions of this message have been removed]
>
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>
>