Re: labgear / loft box with CCTV feed

["ianh1000" <ianh1000@xxxxxxxxx>]

Hi Noel,

I guess it is possible I hve a conflict, it has been working fine
with a B&W camera for a few years. I guess that colour needs a
better signal and B&W will work with a marginal one. I will try
another channel.

Regards
Ian

--- In ukha_d@xxxxxxx, "noel_pilot" <HA@a...> wrote:
>
> Could it be that the channel your RF modulator is set to is
> conflicting with another channel being distributed?!?
>
> Try changing the channel on the modulator,  alternatively
> www.satcure.co.uk i think thats the site, it used to have a good tv
> distribution guide and a calculator for empty tv channels in ur
area!
> HTH
> Noel
>
>
>
> --- In ukha_d@xxxxxxx, "ianh1000" <ianh1000@y...>
wrote:
> >
> > Hi All
> >
> > I am trying to install a new CCTV camera for the babies room. I
have a
> > Labgear MRX390 similar to loftbox, a simple colour camer and an
RF
> > modulator.
> >
> > If I plug the camer and modulator into the TV on a short cable
it all
> > work fine. If I then connect via the dist amp it works with a
test
> > signal but I get no picture when i turn of test to see the
camera.
> >
> > Is it simply that the signal is too low and I need to add a
small amp
> > between the modulator and CCTV input?
> >
> > Any help would be welcome as I am getting a bit frustrated!
> >
> > Thanks in advance.
> >
> > ian
> >
>