Re: Face plate outlets for CT100 ?

["Mal Lansell" <mlansell@xxxxxxxxxxxxxx>]

Don't push-fit plugs fit on f sockets anyway (ie you can use an ordinary
push-fit tv aerial lead with f connector wall paltes)?

I used to do this with the cable TV equipment I had when I lived in the US.
I haven't tried it here, but I think they are the same plugs.

Mal

----- Original Message -----
From: "michael.furlong" <ukha@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Sunday, May 30, 2004 7:37 PM
Subject: RE: [ukha_d] Face plate outlets for CT100 ?


Rick

I have used f type faceplates everywhere and then where I need a pushfit
coax I just make up a lead with f type plug on one end and standard pushfit
coax plug on the other.

Works for me

Mick
-----Original Message-----
From: rick_hughesuk [mailto:rick.hughes@xxxxxxx]
Sent: 30 May 2004 19:21
To: ukha_d@xxxxxxx
Subject: [ukha_d] Face plate outlets for CT100 ?


I have flood wired out loads of CAT5e and CT100, time to start
putting faceplates on the holes in the walls.
CAT5e is easy enough ... the question is what do I use for the CT100,
should I use a common connector . I know many of you have
mentioned `F type' in the past.
If I do terminate all CT100 with F type, I know these will be OK for
SAT feeds . are they also OK for TV feeds ?
Intend using a distribution amp, will F-type be OK for all the points
where I need a TV, or do I need to terminate some of these on
standard TV Coax sockets ?

Not bought any distribution kits yet but want to sort out all the
faceplates.

On a secondary note what is the general opinion on triplexer unit
face plates . see that MK now make one that  is Labgear/Skyhomes
compatible.


Rick