The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Dell monitor mounts for installation in wall


  • To: ukha_d@xxxxxxx
  • Subject: Dell monitor mounts for installation in wall
  • From: "big_red_frog" <anthony.tod@xxxxxxx>
  • Date: Tue, 27 Jan 2004 10:57:22 -0000
  • Mailing-list: list ukha_d@yahoogroups.com; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Hi All,

I am intending to mount 3 17 inch monitors inside teh stud walling
of the place I am building.

I have just purchased a Dell E172 as a possible donor for the screen.

See this link

http://www.aria.co.uk/ProductInfoComm.asp?ID=9615

Not sure if I have made the right descision yet, as I have to check
if this will take the SVGA cable I have run into each place, or if
it is only DSUB, can you do the SVGA to DSUB conversion at the
monitor end?

Anyway, the biggest issue is, that I want to remove the stand and
then mount it properly, looking at the stand, it would appear that a
large part of the rear panel comes off with it, does anyone have any
idea where I could find a replacement panel, suitable for wall mount?

I will try Dell, but maybe people here know of a good solution?


UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk
Post message: ukha_d@yahoogroups.com
Subscribe:  ukha_d-subscribe@yahoogroups.com
Unsubscribe:  ukha_d-unsubscribe@yahoogroups.com
List owner:  ukha_d-owner@yahoogroups.com


Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.