RE: Re: Automating a combi boiler

["Brian G. Reynolds" <brian.g.reynolds@xxxxxxx>]

Afraid not...

All I have is a printed document, a schematic diagram.

This shows a "chock-block" labelled "room thermostat"
and it is this that has the link.

Then on another page there is a line drawing showing the boiler with an
arrow pointing to the rough location of the chock-block, but there are also
lines representing the mains cable and a cable marked "externals
controls lead (not supplied)" so this leads me to thinking they are
different connections.

I suppose I could contact the manufactures?

Thanks again,

B.

-----Original Message-----
From: Dave McLaughlin [mailto:dave@xxxxxxx]
Sent: 17 January 2004 23:15
To: ukha_d@yahoogroups.com
Subject: Re: [ukha_d] Re: Automating a combi boiler


Hi Brian,

More than likely, but as I have not  seen the wiring for your boiler I
can't really make the assumption and say yes. Do you have PDF of the
wiring by any chance or point me to where I can download it?

Dave...

---
Very funny Scotty, now beam down my clothes...!!
---
http://www.v8carlton.com
http://www.embeddedcomputer.co.uk
---


Brian G. Reynolds wrote:

> Does this mean you connect the "thermostat" to the
"link" connections?
> or in my case, the relay across where the link was?
>
> Thanks Dave,
>
> B.

UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk
Post message: ukha_d@yahoogroups.com
Subscribe:  ukha_d-subscribe@yahoogroups.com
Unsubscribe:  ukha_d-unsubscribe@yahoogroups.com
List owner:  ukha_d-owner@yahoogroups.com