The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: Non X10 HA solutions


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Wireless video sending advice


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Wireless video sending advice
  • From: "Phil Harris" <phil@xxxxxxx>
  • Date: Wed, 31 Dec 2003 11:42:22 -0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx


> I've read that some also include remote extenders - any which
> work with the NTL/Telewest Pace cable boxes?

I think the AEI DigiSender claims to work with NTL/Telewest Pace boxes but
be wary of them - the IR receive range (from remote to IR receiver) is
pretty pants as it is the same IR extender circuitry as in the Digi-Eye and
we know that that has a much reduced IR TX/RX range when used for IRDA
rather than 38kHz IR.

> Also, I'd like to have the receiver end wired into my PC in the
bedroom
> which has an Avermedia TV card with a SVideo in - is this possible?

They're all composite only I'm afraid ... and won't take an RGB in so have
to be *FED* composite too.

> Also, will it interfere with any of my wireless X10 or 802.11b
networking?

Wireless X10 no ... 802.11b - well I've always found that the video senders
take 802.11b down completely but some people seem to have got them working
by selecting Channel A on the video sender and a high channel on their
wireless networks.

Phil


UKHA 2004: 15th and 16th May 2004
EARLY BIRD RATE EXPIRES 31/12/03!
http://www.ukha2004.com

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx


Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.