RE: [OT] Corner (90 degree) plastic trunking...

["Hawes,Timothy Edward (GEG)" <haweste@xxxxxxxxxxxxxxx>]

Andy,

Well waddya' know ? look what I found on CPC (sit down first before you
look at the price :-(  )
http://custom1.farnell.com/cpc/product.asp?catalog%5Fname=CPC+Catalogue&product%5Fid=261053

The second item in the list "Bench Trunking + Lid" is the conduit
itself.

Any use ?

HTH,

Tim H.

> -----Original Message-----
> From: Kilgore, Andrew  Sent: 13 February 2004 14:13
>
> Tim,
>
> Yeah I was hoping for something triangular in cross-section.
> I've not seen any either but I figure _someone_ must make
> something like
> it...???
>
> Thanks,
> Andy.
>
> -----Original Message-----
> From: Hawes,Timothy Edward (GEG)  Sent: 13 February 2004 12:56
>
> > -----Original Message-----
> > From: Kilgore, Andrew  Sent: 13 February 2004 10:20
> >
> > Hi all,
> >
> > Does anyone know where I can find some plastic corner
> > trunking (to run up
> > the corner of a wall).
> > Tried my usual haunts but no luck there...
> > Looking for something about 7cm long on both sides.
> >
> > Failing that, anyone done something like this themselves...?
> >
> > Many thanks,
> > Andy.
>
> Andy,
>
> Not quite sure what you're after - something like this ?
> http://www.tlc-direct.co.uk/Main_Index/Trunking_Pvc_Index/Maxi
> _3/index.html
> <http://www.tlc-direct.co.uk/Main_Index/Trunking_Pvc_Index/Max
> i_3/index.html
> >
> (75mm square)
>
> Or do you mean something triangular in cross-section ? Never seen that
> though :-(
>
> HTH,
>
> Tim H.

+